Good quality sound for a good price. Stylish design with a lighted logo makes it look better than the average amps. Planet Audio is a good brand as I have tested this amp, a 1 channel amp, 12″ subs, 3-way 6×9, 6 1/2 combos, and their 10 farad cap no problems at all.
Description. Break out the Bass with the Planet Audio Anarchy AC1500. 1M Monoblock Class A/B Amplifier. This powerful 2-Ohm stable Amplifier features 1500 Watts Max Power with a MOSFET power supply to drive your tunes to the limit.
How do you tune a planet audio amp?
What settings should I set my amp to?
Getting a Good Clean Tone
Select your clean channel or turn the gain down if you don’t have multiple channels.
Turn off all amp effects and effect pedals.
Bring the bass, mid & treble knobs all to 12 o’clock.
Keep the gain fairly low and adjust the volume to a suitable level.
Jam for a while to get a feel for the tone.
Are Planet Audio amps any good? – Related Questions
What frequency should I set my amp to?
Set the crossover point around 10 Hz below the lowest frequency your speakers can produce without issue. (keep in mind that the most common recommendation for crossover frequency is 80 Hz). Once again, play some music. But this time, slowly turn up your receiver’s volume until you hear it begin to distort.
How do I get my planet amp out of Protect Mode?
How to Get Amp Out of Protection Mode:
Disconnect Speakers.
Check the Temperature of the Amp.
Unplug the Head Unit.
Check the Ground Connection.
Check All Cables.
Check Impedance Load.
Reset the Amp’s Gain.
What should I set my subsonic amp to?
For the mainstream listener, setting a subsonic filter around 35 Hz will allow them to hear all their music content, missing nothing on any performance, while protecting their system. Our next articles will also show ways to optimize amp power and cone excursion for the listeners bandwidth.
How can I make my amp sound more rock?
How do I get the ACDC sound on my amp?
To sound like AC/DC, start with the following amp settings:
Gain: 5-6.
Bass: 4-5.
Mids: 5-6.
Treble: 6-7.
What amplifier did paul McCartney use?
What a lot of people do not know is that the 1964 6G6-B Bassman was actually the most recorded amplifier by The Beatles. The amp was first used by Paul McCartney as his main bass amp from 1965 to mid 1967 (he did use a Vox during this time but not as much as the Bassman).
What amps does Def Leppard use?
Amps and Effects
One channel of the Axe-Fx II feeds the front-of-house sound engineer and monitor engineer while the other channel is plugged into a Randall RRM 2-200 stereo power amp. The Randall powers two EVH 4×12 speaker cabinets on stage to give Collen the proper feel and also serves as a stage monitor.
What amplifier does Chris Stapleton use?
Stapleton prefers playing through 1962 Fender Princeton amps. At 57 years old, the amplifiers are hard to find and unreliable.
What amplifier does Eric Clapton use?
Clapton has always preferred to use a Fender for his clean tone and a Marshall for gain. He’s stuck by the famous Fender Twin for most of his career. It is a great pedal platform amp with glistening cleans to suit single coil pickups.
What amp did Van Halen use?
This tone is pretty simple, Eddie Van Halen used his legendary Marshall Plexi amplifier famously cranked to the hilt with every knob turned up to 10 (or 11!) and his iconic Frankenstein guitar with the single humbucker in the bridge. The reverb and room mic effects mixed in also have an influence on this recording.
What amp does Eric Clapton play?
It is with Fender amps however that Eric Clapton is best associated. And again, over the last five decades, Clapton has played a wide variety of different Fender amps. However the two that have arguably had the greatest impact on his tone are the Fender ’57 Custom Twin and the Fender ’57 Custom Champ.
What amp does Jimi Hendrix use?
Jimi Hendrix’s Amps
Jimi Hendrix was one of the earliest users of Marshall amplifiers, and for most of his career he powered his sound with three 100-watt Super Lead valve amp heads.
What amp did Peter Green use?
Some vintage gear carries the patina of both age and history. That’s the case with this month’s featured amp: a 1964 Marshall JTM45 4×10 combo that was owned and played by Peter Green during his years with Fleetwood Mac, and potentially with John Mayall’s Bluesbreakers.
What was Kurt Cobain’s amp?
Kurt’s amplifier of choice for live performance was a combination of the Mesa Boogie Studio . 22 acting as a preamp and a Crest 4801 as his power amp. The first iteration of this setup was the Mesa Boogie paired with Crown Power Base 2 800w Power Amp, but Kurt felt the Crest worked better with the Mesa preamp.
What amp did Foo Fighters use?
What amps do Foo Fighters use? Foo Fighters primarily use Mesa/Boogie amps for driven tones and a Vox AC30 for clean tones.
What amp did Chris Cornell use?
Most of Cornell’s guitar tracks were recorded using a Marshall JMP 50 half stack and Mesa-Boogie Dual Rectifier Solo half stack blended together.
