Hold the Power button (center of the volume knob) + the Right-Seek button at the same time for approximately five seconds.
The display will indicate when the module is resetting. You may then release the buttons.
How do you reset the screen on a Ford Focus?
Why is my sync screen black?
What is a Blank/Black Screen? A blank/black screen on a SYNC 3 equipped vehicle is defined as the Front Display Interface Module (FDIM) having no image while the ignition is on. This may be an event that takes place for as little as a fraction of a second, or may persist as a hard fault.
How do I reset my Ford Focus radio?
Press and hold both the Power button (center of the Volume knob) and the Seek Right button for 10 seconds.
How do I reset my Ford Sync when the screen is black? – Related Questions
Why is my radio display not working?
A damaged or defective fuse might lead your car radio display not to work. This particular fuse sits right between the display unit and the power line. If you installed a newer stereo system by replacing the stock one, there might be an issue where the aftermarket stereo won’t turn on due to a defective fuse.
Why is my radio suddenly not working?
Blown Fuse
The most likely reason for your radio’s sudden death is a blown fuse. All car radios have at least one fuse that protects it from power surges coming from somewhere else in the vehicle. The first thing you should do when your radio stops working is check its fuses and replace any that have blown.
How do I reset my Ford audio system?
How do I reset my Ford Focus radio without the code?
Method 1:
Turn on the ignition.
If the screen says CODE then turn off the radio.
Press and hold the Power/Volume button for 40-50 seconds.
It should unlock your radio in under a minute.
How do you do a hard reset on a radio?
Turn your car on, but do not start the engine. Turn the radio off. Hold the radio power button down for a few minutes until it resets.
How do I reboot my radio?
Unplug the Component
The easiest way to reset an audio component is to disconnect it from the power source, wait 30 seconds, and then plug it back in and try again.
How do you know if a radio fuse is blown?
Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.
How do I reset my Ford touch screen?
To perform a System Reset, press and hold the Seek Up (>>) button while pressing and holding the Radio Power button. After approximately 5 seconds the screen will go black. Allow a 1-2 minutes for the system reset to complete. You may then resume using the SYNC system.
How do I reset my car screen?
How do you fix the touch screen in a car?
Clean your touchscreen.
Reboot the touchscreen by turning it off and back on again.
Recalibrate the screen from the settings menu.
Perform a factory reset.
Why is my car display screen not working?
A cracked touch screen is one of the main reasons that lead to an unresponsive car stereo screen. Check out for visible damages. If the screen has cracks or visible damage, you probably need to repair it. Sometimes, even minute scratches can lead to a faulty touch screen for your car stereo.
How do I fix an unresponsive screen?
On most phones, press your phone’s power button for about 30 seconds, or until your phone restarts. On the screen, you might need to tap Restart .
Important: To learn how to turn safe mode on and off, go to your device manufacturer’s support site.
Turn on safe mode.
Touch the screen.
Turn off safe mode.
Why is my car screen not on?
Check for a Faulty Head Unit, LCD, or Backlight
If that’s the case, then the problem might be one of the following: Your main unit is faulty or damaged. The backlight of the display is defective or broken. The LCD is flawed or damaged.
Why is my car screen dark?
Check to see if your car stereo has a dimmer setting, which can disable the display. If the car audio system does have this setting, try adjusting it to the different dimmer settings. The car stereo may not function properly if the connectors between the receiver and the front panel are not clean.
