Good quality sound for a good price. Stylish design with a lighted logo makes it look better than the average amps. Planet Audio is a good brand as I have tested this amp, a 1 channel amp, 12″ subs, 3-way 6×9, 6 1/2 combos, and their 10 farad cap no problems at all.
Boss Audio is debuting four new models today under its various brands: BOSS Audio BVCP9850W, Planet Audio PCPA975W, Sound Storm Laboratories DD999ACP, and BOSS Elite BE950WCPA.
How do you tune a planet audio amp?
Is Planet Audio the same as boss?
Boss International Group is the manufacturer of 3 major car audio brands, Boss Audio, Planet Audio, Sound Storm Laboratories plus NYNE Bluetooth speakers. We have been in business for 30 years and we are still growing.
Is a Planet audio amp any good? – Related Questions
What frequency should I set my amp to for subs?
Subwoofers: 70-80 Hz (low pass), the most essential purpose of a subwoofer crossover is to block midrange sounds. Car main speakers: 50-60 Hz, the most critical element in main speaker crossovers is to block low-end bass (frequencies 80 Hz and below)
How do you get a punchy bass on a subwoofer?
What phase should I set my subwoofer at?
Typically, though, phase is left at 0° for most applications. While seated in your listening sweet spot, play music with bass content that is familiar to you and then have someone switch the 0/180 phase switch on the sub to 180-degrees. This will let you determine if the bass sounds louder in your seating position.
What wattage is best for subwoofer?
How many watts for subwoofer? As a general rule of thumb, it is best to go with at least 300 watts in order to get enough power for your subwoofer. You can always add more speakers if you want, but it is important that the amp matches the speaker system as well.
What should the settings on my amp be?
Generally, good rock guitar amp settings are:
Gain: 5-7.
Treble: 5.
Mids: 6.
Bass: 6.
How do you set a good sound amplifier?
Turn the receiver volume down. Set the receiver’s fade control all the way to the rear speakers. Again, turn the receiver’s volume up to ¾ full and turn up the rear gain control of your amp until the music distorts, then turn it down so it plays clean again. Turn the receiver volume down.
How do I get my planet amp out of Protect Mode?
How to Get Amp Out of Protection Mode:
Disconnect Speakers.
Check the Temperature of the Amp.
Unplug the Head Unit.
Check the Ground Connection.
Check All Cables.
Check Impedance Load.
Reset the Amp’s Gain.
What should I set my subsonic amp to?
For the mainstream listener, setting a subsonic filter around 35 Hz will allow them to hear all their music content, missing nothing on any performance, while protecting their system. Our next articles will also show ways to optimize amp power and cone excursion for the listeners bandwidth.
How do you get a punchy bass on a subwoofer?
What phase is best for subwoofer?
Typically, though, phase is left at 0° for most applications. While seated in your listening sweet spot, play music with bass content that is familiar to you and then have someone switch the 0/180 phase switch on the sub to 180-degrees. This will let you determine if the bass sounds louder in your seating position.
What should I set my subwoofer slope at?
The subwoofer does not have a supplied passive crossover, use a Low-Pass Filter to block the high frequencies from being sent to the subwoofer. The most commonly used slope options found in car audio are 12 dB per octave or 24 dB per octave.
What frequency is best for bass?
BASS AND UPPER BASS (40-80 Hz/Eto E2)
For normally tuned bass guitar and upright double bass, note fundamentals extend down to E1, (open E). I would consider bass arbitrarily to be below C2 (65.41 Hz). That is two octaves below middle C. The fundamental of a note is its musical pitch.
Which Ohm is best for subwoofer?
4 ohm subwoofers will have a higher electrical resistance, use way less energy and will, therefore, last longer than subwoofers with lower resistance. They also produce less sound in comparison to the 2 ohm ones.
Should subwoofer face the floor?
According to “The Home Theater DIY,” “down-firing subwoofers are intended to be close to the listening area, not part of your TV console.” One hard and fast rule: never put a down-firing sub on its side and never put a front-firing subwoofer face down.
Is a subwoofer better on carpet or hard floor?
Although many people have had this question, there is no perfect answer. While a bare hard flooring can allow the deeper subwoofer sound waves to travel further without being dampened, a carpet can help to balance the sounds in the room together better, depending on where other speakers are placed.