Good quality sound for a good price. Stylish design with a lighted logo makes it look better than the average amps. Planet Audio is a good brand as I have tested this amp, a 1 channel amp, 12″ subs, 3-way 6×9, 6 1/2 combos, and their 10 farad cap no problems at all.
Boss Audio is debuting four new models today under its various brands: BOSS Audio BVCP9850W, Planet Audio PCPA975W, Sound Storm Laboratories DD999ACP, and BOSS Elite BE950WCPA.
How do you tune a planet audio amp?
Is Planet Audio the same as boss?
Boss International Group is the manufacturer of 3 major car audio brands, Boss Audio, Planet Audio, Sound Storm Laboratories plus NYNE Bluetooth speakers. We have been in business for 30 years and we are still growing.
Is Planet audio amp any good? – Related Questions
What frequency should I set my amp to for subs?
Subwoofers: 70-80 Hz (low pass), the most essential purpose of a subwoofer crossover is to block midrange sounds. Car main speakers: 50-60 Hz, the most critical element in main speaker crossovers is to block low-end bass (frequencies 80 Hz and below)
What should the settings on my amp be?
Generally, good rock guitar amp settings are:
Gain: 5-7.
Treble: 5.
Mids: 6.
Bass: 6.
How do you set a good sound amplifier?
Turn the receiver volume down. Set the receiver’s fade control all the way to the rear speakers. Again, turn the receiver’s volume up to ¾ full and turn up the rear gain control of your amp until the music distorts, then turn it down so it plays clean again. Turn the receiver volume down.
How do I get my planet amp out of Protect Mode?
How to Get Amp Out of Protection Mode:
Disconnect Speakers.
Check the Temperature of the Amp.
Unplug the Head Unit.
Check the Ground Connection.
Check All Cables.
Check Impedance Load.
Reset the Amp’s Gain.
What should I set my subsonic amp to?
For the mainstream listener, setting a subsonic filter around 35 Hz will allow them to hear all their music content, missing nothing on any performance, while protecting their system. Our next articles will also show ways to optimize amp power and cone excursion for the listeners bandwidth.
How do you get a punchy bass on a subwoofer?
What’s a good LPF setting?
As a general rule, the Low-Pass Filter should be set at a value approximately equal to (or below) 70% of your main speaker’s lowest frequency response. For example, your speaker’s frequency response goes down to 43Hz. 70% of 43Hz equals 30.1, so you should set the subwoofer’s low pass filter to 30Hz.
What should I set my subwoofer slope at?
The subwoofer does not have a supplied passive crossover, use a Low-Pass Filter to block the high frequencies from being sent to the subwoofer. The most commonly used slope options found in car audio are 12 dB per octave or 24 dB per octave.
Which Ohm is best for subwoofer?
4 ohm subwoofers will have a higher electrical resistance, use way less energy and will, therefore, last longer than subwoofers with lower resistance. They also produce less sound in comparison to the 2 ohm ones.
Should subwoofer face the floor?
According to “The Home Theater DIY,” “down-firing subwoofers are intended to be close to the listening area, not part of your TV console.” One hard and fast rule: never put a down-firing sub on its side and never put a front-firing subwoofer face down.
Should subwoofers be facing up or down?
Facing the subwoofer upward while in the trunk, gives you big bass without consuming a lot of space. This direction offers crisp sound with a slight advantage to high frequencies and treble, and won’t rattle loose parts in your vehicle as much.
Where should you not put a subwoofer?
Try to keep the sub within 4 or 5 feet of the left or right front speakers. Which leads to my next bit of advice, don’t put the subwoofer in a corner. Granted, there are significant advantages to corner placement, mainly that in a corner the sub will produce more bass, with lower distortion.
How far from the wall should a subwoofer be?
Additionally, a sub’s close proximity to a flat wall can cause a harsh, rumbling, unpleasant sound. And if your subwoofer is a ported design (a subwoofer with an opening to allow airflow), you’ll want to keep it twice the diameter of the port (typically 6-12 inches) away from a wall to allow airflow out of the port.
Where is the best place to place a subwoofer?
Subwoofer placement in the front of the room is the most common and usually results in the best blending with the main speakers and center channel and minimizes localization effects. Bass is omni-directional.
Should a subwoofer be on the floor or up high?
Quick Answer: there’s a reasonable chance that elevating a subwoofer will improve how it sounds, and a subwoofer sitting on the floor can cause various issues as well. But, it’s also entirely possible for a subwoofer to perform optimally when sitting on the floor since that’s where many are designed to be.
