The right-front speaker wires are gray, left-front speakers are white, right-rear speakers are purple, and left-rear speakers are green. Ground wires are black, antenna wires are blue, and amplifier wires are blue with a white stripe.
Manufacturers have made connecting a car stereo to an wiring harness relatively easy with color coded wires. In the table below, we show what those wires do and what the colors mean.
What color are factory speaker wires?
Car Stereo Wiring Diagram / Wire Color Guide
Color
Type
Polarity
Purple / Black Stripe
Speaker
–
Green
Speaker
+
Green / Black Stripe
Speaker
–
Brown
Misc.
+
What color is the remote wire on a factory radio?
The blue/white stripe remote turn on wire has a number of other names such as accessory wire, system remote control wire, etc… Some of the confusion about this wire may come from the different wiring methods between a factory and an aftermarket head unit.
What color wires go together in a car stereo? – Related Questions
What are the wire color codes?
U.S. Electrical Wiring Color Codes
Phase 1 – Black.
Phase 2 – Red.
Phase 3 – Blue.
Neutral – White.
Ground – Green, Green with Yellow Stripe, or Bare Wire.
What is the orange wire on radio harness?
Is the remote wire blue or blue and white?
What is the wire color and function of each pin on the 16-pin wiring harness?
The Key 1, Key 2, and Key GND wires will be used to interface steering wheel controls if your vehicle came equipped. Most newer vehicles will also need the Axxess ASWC-1 to translate the steering wheel controls to this stereo. Helpful?
Where does orange wire go on radio?
Where do you connect the yellow wire on a car stereo?
What wires are positive and negative on a car stereo?
typically, the positive wire is red and the ground, or negative, is black. However, most speaker wires don’t do colors. Good news is, with speakers it doesn’t really matter which one you choose as your positive and which as your negative, just so long as you are consistent.
What color wires are positive or negative?
The positive current must be red.The negative current must be black. The ground wire, if present, must be white or grey.
What color wire is negative and positive?
In the world of DC electronics, the accepted wiring convention is that the red wire carries the positive voltage, and the black is circuit ground. Usually the red is marked as + (plus) and the black is marked as – (minus). Notice that in both AC electricity and DC electronics, there is a black wire.
What color is positive and negative cables?
Each battery has two metal terminals. One is marked positive (+), the other negative (-). There are also positive and negative cables in the jumper cable set. The red one is positive (+), the black one is negative (-).
What are the 3 colored wires?
DC Power
Positive – red wire.
Negative – black wire.
Ground – white or gray wire.
What color wires go together?
The protective ground is green or green with yellow stripe.The neutral is white, the hot (live or active) single phase wires are black , and red in the case of a second active.
