The Key 1, Key 2, and Key GND wires will be used to interface steering wheel controls if your vehicle came equipped. Most newer vehicles will also need the Axxess ASWC-1 to translate the steering wheel controls to this stereo. Helpful?
Do I need to hook up power antenna wire?
Yes, these two wires should be connected together. This is what allows the radio to retract the antenna when it isn’t being used. Just because your wiring harness has a connection for this wire, it doesn’t necessarily mean that your car has this kind of motorized antenna.
What color wires go together in a car stereo?
What is the orange wire for on a car stereo? – Related Questions
What color wires go together?
The protective ground is green or green with yellow stripe.The neutral is white, the hot (live or active) single phase wires are black , and red in the case of a second active.
What color wire goes where?
Black wires are hot wires that run to the electrical outlet from the switch. Red wires are hot wires common in a 240-volt outlet or when a wall switch controls the outlet. Blue and yellow wires are hot wires for ceiling fans and three- or four-way switches. White or gray electrical wires are neutral wires.
How do you connect car stereo wires together?
What are the 3 colored wires?
DC Power
Positive – red wire.
Negative – black wire.
Ground – white or gray wire.
What wires do you put together to hot wire a car?
Can I connect red and black wires together?
Red and black wires are both hot or line wires and should not be connected together.
What color wires go together for a ceiling light?
The ground wire is the bare copper wire and should be connected to the green grounding screw in the crossbar. Wire black to black (hot) and white to white (neutral), and make sure that all connections are snug.
What to do with the red wire when installing a ceiling fan?
Copper or green wire is the ground wire and keeps the fan from experience power surges. If there is a blue and black wire coming from the household circuit, there should be two switches on the wall. If there is a red wire coming from the ceiling, it is hooked up to the wall switch.
Does red or black connect to positive?
The red one is positive (+), the black one is negative (-). Never connect the red cable to the negative battery terminal or a vehicle with a dead battery.
What happens if you mix up positive and negative wires?
Switching which wire is connected to positive or negative (without regard to color) will typically RUIN/TOAST/BLOW UP most anything electronic. Of course incandescent lamps don’t care, and DC motors will typically run in the opposite direction if you switch the polarity.
Do you connect red to red or red to black?
The order of the connection (red to dead, red to donor, black to dead, black to metal) reduces the chance of shorting the good battery. A quick test that there is enough voltage for the donor, be sure that the car giving he jump start’s headlights are steady and bright when the car is started.
Does black go with positive or negative?
In the world of DC electronics, the accepted wiring convention is that the red wire carries the positive voltage, and the black is circuit ground. Usually the red is marked as + (plus) and the black is marked as – (minus). Notice that in both AC electricity and DC electronics, there is a black wire.
Which cable do you take off first when jumping a car?
Step 10: Disconnect the black jumper cables first, then disconnect the red ones. Once the dead car is running, you may disconnect the jumper cables, starting with the black, negative cable clamps. Do not let the clamps touch each other while any part of the cables is still attached to a car.
Do I connect positive or negative first?
“Positive first, then negative. When disconnecting the cables from the old battery, disconnect the negative first, then the positive. Connect the new battery in the reverse order, positive then negative.”
